MiG-29 Fulcrum
Posted: Fri May 11, 2018 6:28 pm
Hi,
I’ve just used ADFFS 2.64 to image MiG-29 Fulcrum as a JFD on my RiscPC. Risc OS 3.50 and not a Strong ARM.
When I boot floppy for the image on my Risc PC, I get an error message as soon as I press the first key when entering the protection word from the manual (“Illegal address (e.g. wildly outside array bounds) Postmortem requested ...”)
When I boot floppy for the same image on my Pi (Risc OS 5.23), I don’t even get as far as the copy protection prompt - I get a different set of error message immediately (“CallBack handler... ) (Fair enough because post 3.70 OS).
... but when I run it on my Pi using ADFFS inside !ArcEm with Risc OS 3.10, it runs fine!
Pi and Risc PC setup both run downloaded JFDs fine.
Any suggestions? (other than running ADFFS inside !ArcEm all the time!)
Thanks.
I’ve just used ADFFS 2.64 to image MiG-29 Fulcrum as a JFD on my RiscPC. Risc OS 3.50 and not a Strong ARM.
When I boot floppy for the image on my Risc PC, I get an error message as soon as I press the first key when entering the protection word from the manual (“Illegal address (e.g. wildly outside array bounds) Postmortem requested ...”)
When I boot floppy for the same image on my Pi (Risc OS 5.23), I don’t even get as far as the copy protection prompt - I get a different set of error message immediately (“CallBack handler... ) (Fair enough because post 3.70 OS).
... but when I run it on my Pi using ADFFS inside !ArcEm with Risc OS 3.10, it runs fine!
Pi and Risc PC setup both run downloaded JFDs fine.
Any suggestions? (other than running ADFFS inside !ArcEm all the time!)
Thanks.